The solutions for milk filling machine
Common faults in the use of milk filling machine, and the corresponding solutions are given.
First, milk filling machine filling quantity is not allowed or not out of the material. As far as the market is concerned, most milk has a net content, that is, there is a requirement for filling volume. This puts forward a higher demand for milk filling machine. According to the manufacturer, if the liquid level is unstable due to the insufficient liquid in the tank, the liquid can be supplemented or the square ball valve on the head of the filling machine can be adjusted again, the filling time of the filling machine can be reset (the filling time is lengthened), or the filling speed of the filling machine can be slowed down to solve the problem.
In addition, if it is not the material liquid problem, you can check whether there is foreign matter in the three-way control valve, or whether there is foreign matter in the filling channel of the filling machine. If there is, mainly at the entrance of the chute or in the mouth of the filling material, timely cleaning and dredging. If the filling spool is jammed or delayed opening, it is necessary to install the spool in a good position from the beginning. If delayed opening, need to adjust the thin cylinder throttle valve. Finally, it should be noted that if the check valve does not open, it will not result in the equipment not discharging.
Second, individual valves or cylinders slow or do not work. Usually caused by the failure of the control valve, it is necessary to check the milk filling machine to control the output of the output display lamp is working properly, confirm its normal work before the following inspection. In addition, check the solenoid valve solenoid coil plug, if the plug is damaged or not inserted, may also cause the valve or cylinder slow or not working. If the solenoid coil is damaged, the fault can be eliminated after the coil is replaced.
Third, filling machine filling volume is not stable, when more or less. Milk filling machine filling more or less, not only affect the whole filling production line, but also lead to the net milk content instability. To this end, users can first check whether there is garbage jam phenomenon in the material tube or the material box outlet. If any, it should be removed in time. Then check whether there is water drop in the compressed air, if there is, it should be removed in time, and pull out the filling volume is not accurate to fill the air pipe on the head and remove water in time.
Fourth, drip leakage occurs when the feeding head stops working. According to a mechanic, this may be the system pressure is insufficient, the wear of the feed ball valve or the damage of the feed nozzle orifice lead to the drip of the feed liquid. In view of this situation, the user can first check the air supply pressure of the equipment system, such as the pressure is too low, check whether the air supply pipeline is damaged, and adjust the pressure of the pressure reducing valve at the air supply port, so that it reaches the specified value. If the filling ball valve, filling nozzle orifice wear or damage, timely maintenance or replacement can be.
In fact, in addition to these, there are also filling machine material liquid from the rear end of the cylinder, the touch screen display is normal, but there is no reaction after pressing each key, check whether the programmable output indication and other problems, users should timely check, find the cause and take appropriate measures to eliminate the fault, to ensure the normal operation of the filling machine.
As a category of liquid filling machine, milk filling machine not only improves the filling efficiency, saves labor costs, but also occupies an important share in the sales of filling machinery and promotes the rapid development of milk industry.